sssooo
Ohio
Senior Member
Joined: 03/16/2008
View Profile
 Offline
|
I just stopped for the nite and my steps won’t come out I checks the plug it’s ok
I have a 2018 Fleetwood Bounder 36”
* This post was
edited 04/16/22 06:40pm by sssooo *
|
MountainAir05
New Mexico
Senior Member
Joined: 01/27/2007
View Profile
Offline
|
door switch at door or magnetic door switch on the screen. Do not stick your hand in there. Would cut it off.
If you can get under from the side try a screw driver or hammer. Jump the door switch and the magnetic switch if that did not work. Maybe a fuse.
|
sssooo
Ohio
Senior Member
Joined: 03/16/2008
View Profile
Offline
|
I checked the magnets it not that
Thanks
|
enblethen
Moses Lake, WA
Senior Member
Joined: 01/05/2005
View Profile
|
Blown fuse for control or blown fuse for motor.
Door overide switch on
Bud
USAF Retired
Pace Arrow
2003 Chev Ice Road Tracker
|
sssooo
Ohio
Senior Member
Joined: 03/16/2008
View Profile
Offline
|
I looked at my fuses that are in my bathroom they all checked ok ?
|
|
|
craig7h
Branson MO area
Senior Member
Joined: 03/23/2002
View Profile
Offline
|
I guess my first question is, does the motor have power? Can you hear it try and run when you open or close the door?
If the motor has power and tries to operate, you might what to check this. Could the steps be binding putting pressure on the system which will shut if off. The pivot points on the steps may be dirt and need lube of some type. Have you gotten underneath and looked to see if the motor assembly was still attached to the frame. The reason I asked that was last year my steps stopped working but the motor was running. I looked underneath and the four screws holding the motor assembly had become loose and sheared off.
Good Luck
Itasca Meridian SE 36g
Road Master Tow Dolly
|
dougrainer
Carrolton, Texas
Senior Member
Joined: 06/11/2007
View Profile
Offline
|
The simplest check is also easy. Under the step is an amber light. WATCH the light and have someone OPEN and CLOSE the door with engine running. IF the light goes ON and OFF with the opening and closing, the wiring is OK and the probable failure is the step motor. SAME procedure with engine running and opening and closing the door. Tap(bang) on the step motor with a hammer. IF the step then functions the motor had a dead spot in the armature and needs replaced. It will probably work after you do this but WILL fail again. Doug
|
wa8yxm
Davison Michigan (East of Flint)
Senior Member
Joined: 07/04/2006
View Profile
Offline
|
Fuses in bathroom may not be proper fuse block
All motor homes have at least 2 fuse blocks
some 3 or more (mine had 4)
Step fuses on my Gasser were in the "Intellect Battery Control Center" box.
Home was where I park it. but alas the.
2005 Damon Intruder 377 Alas declared a total loss
after a semi "nicked" it. Still have the radios
Kenwood TS-2000, ICOM ID-5100, ID-51A+2, ID-880 REF030C most times
|
sssooo
Ohio
Senior Member
Joined: 03/16/2008
View Profile
Offline
|
Where is that block ?
Scott
|
RedRollingRoadblock
Oregon
Senior Member
Joined: 11/26/2007
View Profile
Offline
|
Should be first compartment to the rear of your entry door. Black box about 10x8 inches. Fuse F3 and F4. https://rvcustomproducts.com/f73-1020
|
|
|
